In the case of the "Top Opening" the reference lines will be aligned with the top and bottom of the wall. Make sure to center them on the wall and are flush to the bottom. ![]() Use the "Skittles ISO" PDF to see where each one goes. Use spray adhesive to adhere each profile to the appropriate wall. To finish the the cutting, print out the different ". Using a 13/32" drill bit on a drill press, 7/16" can be used, drill to a depth of 2-3/4". To drill this out, clamp a scrap piece, cut to the same height, to the side where the slot will be. The front wall will have an opening for the top to sit in assisting with spinning the top. If you choose to use dado's, cut them to a depth of 1/4" as shown in the drawing. With all that in mind, use the measurements from the "Skittles Shop Drawing" PDF to cut out the base and walls of the game. Some measurements might have to change to accommodate the difference in thickness. 1/2" material can be used for the walls to lighten the whole game.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |